Changing the protocol
This section describes how to change the protocol.
1. Press [SMB] or [NCP].
A confirmation message appears.
2. Press [Yes].
Changing the protocol will clear all settings made under the previous protocol.
3. Enter each item again.
• p.154 "Using SMB to Connect"
• p.165 "Using NCP to Connect"
Changing the registered FTP folder
This section describes how to change the registered FTP folder.
1. Press [Change] under "Port Number".
2. Enter the new port number, and then press the [ ] key.
3. Press [Change] under "Server Name".
4. Enter the new server name, and then press [OK].
5. Press [Change] under "Path".
6. Enter the new path, and then press [OK].
Deleting an FTP Folder
This section describes how to delete the registered FTP folder.
6. Registering Addresses and Users for Scanner Functions
164
To Next Page
Loading...
