Use the number keys to enter a value in 1 mm (0.01") units in the ranging from 35 mm (1.00") to 40
mm (1.50").
Program Fold 1
Specify the "Programmed Fold 1" fold type for each paper size.
This menu appears only when the cross folding finisher is installed.
Specify "Special Fold 1", "Special Fold 2" at the cross folding finisher.
Preview Area Settings
Specify the default settings of preview area, area size, and orientation for previewing stored document
at the control panel.
This setting is effective when a preview of an enter image cannot be displayed due to document size.
Paper Size Standard for Cut Paper
Specify "Engineering" or "Architecture" as the default paper size detect method.
The default setting is Architecture.
• p.10 "Accessing User Tools"
Output Tray Settings
• If the folding finisher is installed and a folding option is selected, either the front paper exit or the
folding finisher will be used for paper output, regardless of the current paper exit setting.
• If the folding finisher is used for paper output, the tray used will differ, depending on the fold type
selected.
2. System Settings
54
To Next Page
Loading...
