Reproduction Ratio
This section describes the user tools in the Reproduction Ratio menu under Copier / Document Server
Features.
Default settings are shown in bold type.
User Reduce/Enlarge Ratio
You can register up to three frequently used Reduce / Enlarge ratios other than the fixed Reduce /
Enlarge ratio and have them shown on the initial display. You can also change registered Reduce /
Enlarge ratios.
When you select [User Reduce/Enlarge Ratio] on the copier screen, the ratio can be set from 25.0
to 400.0%, using the number keys.
• Metric version:
The default setting for "F1" is 70.7%.
The default setting for "F2" is 141.4%.
The default setting for "F3" is 200.0%.
• Inch version (Engineering):
The default setting for "F1" is 64.7%.
The default setting for "F2" is 129.4%.
The default setting for "F3" is 200.0%.
• Inch version (Architecture):
The default setting for "F1" is 66.7%.
The default setting for "F2" is 133.3%.
The default setting for "F3" is 200.0%.
Reproduction Ratio
Specify the enlargement and reduction ratios that appear if [Reduce / Enlarge] is pressed on the
copier screen.
When you select [User Reduce/Enlarge Ratio], the ratio can be set from 25.0 to 400.0%, using the
number keys.
Reproduction Ratio
95
To Next Page
Loading...
