System Status/Job List Display Time
Specify how long to display the System Status and Job List display for.
The default setting is On, 15 second(s).
By selecting [On], you can specify a display time between 10 and 999 seconds.
Interleave Print
You can set the timing for changing modes when Print Priority has been set to [Interleave].
The default setting is 10 sheet(s).
You can set the number from 1 to 20 sheets using the number keys.
Feed Start Method
Specify whether feeding starts automatically or after pressing the [Start] key.
The default setting is Auto.
Original Feed Delay 2
Specify the duration of the pause immediately after originals are first fed into the machine. If originals
frequently feed in slanted, or you are using special originals, set the delay accordingly.
The default setting is 1 second(s).
The time can be set from 1 to 5 seconds.
Original Feed Delay 1
Specify the duration of delay before an original is fed into the machine after being set. If originals
frequently feed in slanted, or you are using special originals, set the delay accordingly.
The default setting is 1 second(s).
The time can be set from 0 to 5 seconds.
Fine Ratio Adjustment: Copier
Depending on paper type, environment, and humidity, copy paper can expand or shrink slightly. This
means that the size of the copy and the original do not match. If this happens, specify the vertical and
horizontal correction ratio. You can specify this setting for each paper type (plain, translucent, film
and recycled paper).
General Features
51
To Next Page
Loading...
