Check the length of the power cord between the machine and power supply.
Make sure the power cord is not coiled or wrapped around any object such as
a table leg. Coiling the power cord can cause excessive heat to build up and
could cause a fire.
Make sure that the area around the power source is free of obstacles so the
power cord can be removed quickly in case of an emergency.
Make sure that the power cord is grounded (earthed) at the power source with
the ground wire on the plug.
Connect the power cord directly into the power source. Never use an
extension cord.
When you disconnect the power plug from the power source, always pull on
the plug, not the cable.
After Installation, Servicing
Points to Confirm with Operators
At the end of installation or a service call, instruct the user about use of the machine.
Emphasize the following points.
Show operators how to remove jammed paper and troubleshoot other minor problems
by following the procedures described in the operating instructions.
Point out the parts inside the machine that they should never touch or attempt to
remove.
Confirm that operators know how to store and dispose of consumables.
Make sure that all operators have access to an operating instruction manual for the
machine.
Confirm that operators have read and understand all the safety instructions described
in the operating instructions.
Demonstrate how to turn off the power and disconnect the power plug (by pulling the
plug, not the cord) if any of the following events occur: 1) something has spilled into the
product, 2) service or repair of the product is necessary, 3) the product cover has been
damaged.
Caution operators about removing paper fasteners around the machine. They should
never allow paper clips, staples, or any other small metallic objects to fall into the
machine.
To Next Page
Loading...
