Safety Instructions for this Machine
Prevention of Physical Injury
1. Before disassembling or assembling parts of the machine and peripherals, make sure
that the machine and peripheral power cords are unplugged.
2. The plug should be near the machine and easily accessible.
3. If any adjustment or operation check has to be made with exterior covers off or open
while the main switch is turned on, keep hands away from electrified or mechanically
driven components.
4. The inside and the metal parts of the fusing unit become extremely hot while the
machine is operating. Be careful to avoid touching those components with your bare
hands.
5. To prevent a fire or explosion, keep the machine away from flammable liquids, gases,
and aerosols.
Health Safety Conditions
1. If you get ink in your eyes by accident, try to remove it with eye drops or flush with
water as first aid. If unsuccessful, get medical attention.
2. If you ingest ink by accident, induce vomiting by sticking a finger down your throat or
by giving soapy or strong salty water to drink.
Observance of Electrical Safety Standards
1. The machine and its peripherals must be installed and maintained by a customer
service representative who has completed the training course on those models.
Safety and Ecological Notes for Disposal
1. Dispose of replaced parts in accordance with local regulations.
2. Used ink and masters should be disposed of in an environmentally safe manner and in
accordance with local regulations.
Symbols
This manual uses several symbols. The meanings of those symbols are as follows:
See or Refer to
Core tech manual
Clip ring
E-ring
Screw
Connector
To Next Page
Loading...
