Ricoh C274

Optional Installation
SM 2-15 C274
Installation
1. Attach the printer controller board [E] to the bracket [B] (x4).
2. Attach the bracket [C] to the bracket [B] (x2).
3. Connect the connector [D] to the socket on the right side of the board [E].
 Make sure that the connector is securely connected to the socket.
4. Attach the bracket assembly [F] to the same place that the bracket [A] (Step 1) was
installed (1 screw).
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA