Optional Installation
C274 2-16 SM
In this step, only use the M3x6 screw included with the Interface board Type
20.
5. Connect the socket [J] on the interface board to CN108 [K] on the MPU [L].
Make sure that the socket is securely connected to CN108.
6. Connect the connector [H] to the socket [G] on the interface board.
7. Attach the interface board [I] to the bracket assembly [F] (x 2).
8. Connect the connector [O] to CN102 on the MPU [N].
Make sure that the connector is securely connected to CN102.
9. Clamp the harness to the five places shown (#1-5) around the MPU (=x5).
Do not connect the connector [M] anywhere. Leave it unconnected.
To Next Page
Loading...
