• The copy display is set as the default screen when the machine is turned on. You can change this
default setting under Function Priority. See “System Settings”, Network and System Settings Guide
.
System Reset
This section explains System Reset.
After finishing a job, the machine waits a specified length of time and then restores its settings to the default
values specified under Function Priority. This function is called “System Reset”. For the procedure for
specifying default settings under Function Priority, see “System Settings”, Network and System Settings
Guide .
To change the length of time that the machine waits before restoring its settings to their default values, use
the System Auto Reset Timer setting. See “System Settings”, Network and System Settings Guide .
2. Getting Started
72
To Next Page
Loading...
