Ricoh D127 - Page 140

Adjusting Copy Image Area
D127/D128 4-58 SM
 The diagram shows the paper on the copy tray. Note that the paper is output with the
face down.
SP Specification
SP1-001-001 (All Trays)
0 ± 2 mm
SP1-001-002 (By-pass)
0 ± 2 mm
SP1-001-003 (Duplex)
0 ± 4 mm
5. Adjust the leading edge registration (SP1-001).
6. Measure the distance between the side edge of the image area and the side edge of the
paper [B].
SP Specification
SP1-002-001 (1st tray)
0 ± 2 mm
SP1-002-002 (2nd tray)
0 ± 2 mm
SP1-002-003 (3rd tray)
0 ± 2 mm
SP1-002-004 (By-pass)
0 ± 4 mm
SP1-002-005 (Duplex)
0 ± 4 mm
7. Adjust the side-to-side registration (SP1-002).
8. Select "Cancel" in SP2-109-001 after finishing the adjustment procedure.