System Service Mode
D127/D128 3-158 SM Appendix
3.1.5 SCANNER PROGRAM MODE TABLE (SCANNER SP TABLES)
Service Table Key
Notation What it means
[range / default /
step]
Example: [-9 to +9 / +3.0 / 0.1 mm step]. The setting can be adjusted
in the range ±9, value reset to +3.0 after an NVRAM reset, and the
value can be changed in 0.1 mm steps with each key press.
italics Comments added for your reference.
* This value is stored in NVRAM. After a RAM reset, the default value
(factory setting) is restored.
DFU Denotes "Design or Factory Use". Do not change this value.
SP1 Mode Number Function and [Setting]
1001* 5 Scan NV Version Displays the scanner NV version.
This shows as following: Function name _
Model name _ Version
1005* 1 Erase Margin (Remote
Scan) Range from 0 to 5
mm
Creates an erase margin for all edges of the
scanned image.
The margin color (Black or White) depends on
color-tone and invert settings.
[0 to 5 / 0mm / 1mm step]
1009* 1 Remote Scan disable Enables or disables the network TWAIN
scanner function.
[0: Enable, 1: Disable]
1010* 1 Non Display ClearLight
PDF
Sets the clear light PDF display ON/OFF
[0: OFF 1: ON]
1011* 1 Org Count Disp Sets the original counter display ON/OFF
[0: OFF 1: ON]
To Next Page
Loading...
