Ricoh D127 - Scanner Hp Sensor; Scanner Motor

Scanner Unit
SM 4-9 D127/D128
Replacement
and
Adjustment
4.4.3 SCANNER MOTOR
1. Push the spring [A] located on the opposite side of the scanner motor [B] to loosen the belt [C]
from the scanner motor gear.
2. Remove the screws on the top of the scanner motor [B] (
x 4).
3. Turn the scanner motor [B] back. Then remove the screws and the harness on the back (
x
2
x1).
4.4.4 SCANNER HP SENSOR
1. Rear cover (
p.4-3 "Rear Cover")
2. Scanner Cover and Exposure Glass (
Scanner Cover and Exposure Glass)
3. Two of the brackets [A] [B] and the rail [C] (
x 6)
4. Scanner HP sensor [D] (
x 1, x 1)