Ricoh D127 - Gigabit Ethernet

Controller Options
D127/D128 2-34 SM
 This SD card must be inserted into Slot 2, the lower slot.
2.6.5 GIGABIT ETHERNET
 Unplug the main machine power cord before you do the following procedure.
1. Remove the I/F-slot cover [A] (
x 2).
2. Install the Gigabit Ethernet board (Knob-screw x 2) into the I/F-slot [B].
3. Attach one ferrite core [A] to the end of the Ethernet interface cable, and then attach the other
ferrite core [B] about 10cm from the end of the Ethernet interface cable.
4. Connect the Ethernet interface cable to the Gigabit Ethernet port.
Make sure that the machine can recognize this option (see 'Check All Connections' at the end of
this section).