System Service Mode
SM Appendix 3-23 D127/D128
SP Mode
Tables
2995* ID Sensor Detection Interval
2995 1
Warming-up [0 to 999 / 480 / 1 min/step]
After energy saving mode activates, ID sensor warming-up will take place in
this SP’s value min later.
2995 2
Number of Pages [0 to 999 / 100 / 1 sheet/step]
Sets the number of pages as the trigger of “SP2-995-003” setting action.
(Counter: “SP2936-001”)
2995 3
JobEnd / Interrupt -
Sets the condition at which ID sensor control takes place.
2996* Transfer Roller Cleaning [0 = No / 1 = Yes]
2996 1
Cleans or does not clean the transfer roller before each job. Select “1” if the
backside of the paper becomes unclean when output. Note that the copier
takes a longer time to output the first copy when you select “1”. If you select
“0”, the transfer roller is never cleaned.
2996 2
Interval [0 to 100 / 50 / 1 /step]
When the “SP2-996-003” counter is over this SP’s value, Transfer roller
cleaning is activated on the Job-End timing. If this SP’s value is 0, cleaning
doesn’t act.
2996 3
Counter [0 to 255 / 0 / 1 /step]
The counter Applying to “SP2996-002” (Interval).
2998* PCU Reverse Rotation Time
2998 1 Wait Time [0 to 999 / 300 / 1 /step= 30ms]
2998 2 Reverse Time [0 to 99 / 60 / 1 /step= 6ms]
2998 3
Brake Time [0 to 99 / 0 / 1 /step= 3ms]
DO NOT use this SP in usual operations.
To Next Page
Loading...
