Ricoh D127 - Page 299

System Service Mode
SM Appendix 3-43 D127/D128
Appendix:
SP Mode
Tables
5114 Optional Counter I/F CTL
[0: Not installed/ 1: Installed (scanning
accounting)]
001 MF Key Card Ext. Japan use
5118 Disable Copying
001
[0: Not disable / 1: Disable]
Sets copy disabled or enabled.
5120*
Mode Clear Opt. Counter
Removal
[0=Yes / 1=Standby only / 2=No]
5120 1
Specifies the condition to reset the copy job settings when the key counter is
removed.
 0: Y = Yes: The settings are cleared when the counter is removed.
 1: StdBy = Standby only: The settings are cleared when the counter is
removed at the end of a job.
 2: N = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of
these setting.
5121* Counter Up Timing [0 = Feed In / 1 = Exit]
5121 1
Selects the count-up timing.
 0 = Feed: At each paper feed
 1= Exit: At each paper exit
5127 APS Mode
001
[0: Not forbidden / 1: Forbidden]
Sets APS forbidden or not.
APS means “Auto paper size selection”.