11. Remove the support bracket [11] (
x 3).
12. Attach the heater harness (Long) [12] to the connector [13] on the board.
13. Attach the clamp (Large) [14]
14. Lead the heater harness (Long) [12] through the clamp (Large) [14] toward inner side of the
copier as shown.
15. Attach the clamp (Large) [15].
16. Pass the heater harness through the hole [16] to the rear of the copier.
17. Attach the grounding wire (Long) [17] (
x 1, Washer x1, Spring washer x1).
To Next Page
Loading...
