Paper Tray Unit Heater
D127/D128 2-22 SM
2. Remove the rear cover [1] from two of the paper tray units ( x 4).
Right screw on the picture is a shoulder screw.
3. Attach the heater [2] to the lower paper tray unit (
x 2).
4. Put the clamps (Small) [3] in the holes.
5. Joint the connector [4] to the heater harness (Mid) [5].
6. Pass the heater harness (Mid) [5] through the hole [6].
7. Attach the heater harness (Mid) through the clamps as shown.
8. Attach the harness cover [7]. (
x 2, Washer x 2, Spring Washer x 2)
To Next Page
Loading...
