Paper Tray Unit Heater
D127/D128 2-26 SM
28. Attach the grounding wire (Long) [23] (
x 1, Washer x1, Spring washer x1).
29. Attach the grounding wire (Short) between [24] to [25] through the hole. (
x 2, Washer x2,
Spring washer x2).
30. Attach three of the clamps (Mid) [26] [27] [28].
31. Attach the clamp (Mid) [29] [30].
32. Connect the heater harness (Long) to the heater harness (Mid).
33. Attach the heater harness through the clamps as shown.
Be sure to make the bind attached on the heater harness upper than the clamp (Mid) [29]
[30].
34. Remove the drawer from the lower paper tray unit.
35. Attach the caution decal [31] in the bottom of the lower paper tray unit as shown.
36. Reassemble the copier.
37. Plug in the power cord, and check the operation.
To Next Page
Loading...
