Copying Only A Selected Portion Of The Original
You can copy a portion of the original instead of the entire original.
Press and hold the Function Select key for at least three seconds
to tell the copier to copy only a portion of the original. A “P” (for Partial)
will start blinking in the lead margin display. Then, proceed as for a
usual copy, with a sheet of paper or with the roll feeder.
As the original is fed into the copier, press the Function Select key
when the beginning of the part you want to copy (a) goes in; the “P” will
stop blinking and stay on. Press the Function Select key again when
the end of that part (b) goes in; the “P” will start blinking again.
Finally, press and hold the Function Select key for another 3 seconds
to turn the function off.
Notes
p
To copy a portion of the original that includes its first 15 cm (6"),
you must press the Function Select key for (a)
before setting
the original.
p
To copy the bottom portion of the original, simply skip pressing
the Function Select key at (b).
p
You can’t add a margin. The length of the margin affects where
the copier starts and stops copying, so that with a margin, you
can’t set (a) and (b) accurately.
d
a
b
Original
d
Copy
COPYING Copying Only A Selected Portion Of The Original
10
To Next Page
Loading...
