Ricoh FW770 - Adjusting the Fusing Temperature Manually

Copy Settings
28
3
B
When the wait indicator goes off and the ready and the set original indica-
tor go on, the copier enters the ready condition.
Note
❒ Even if you select the media type correctly, creasing might occur depend-
ing on the temperature or humidity. If this happens, adjust the fusing tem-
perature manually. See the next page.
Adjusting the Fusing Temperature Manually
A
Press the {
{{
{Copy Media}
}}
} key to turn on the Translucent or Film indicator that
you want.
B
Hold down the {
{{
{Copy Media}
}}
} key for 3 seconds until beep. The indicator
show the current fusing temperature. The unlit indicator shows the current
temperature settings.
C
Press the {
{{
{i
ii
i}
}}
} key to decrease the temperature, and press the {
{{
{j
jj
j}
}}
} key to
increase the temperature. The number of temperature levels (7 levels) avail-
able depends on the paper type:
• Plain paper : 1234567
• Translucent paper: 1234
• Film : 1234
D
After you have finished setting the temperature, press the {
{{
{Copy Media}
}}
} key.