Ricoh FW770 - Preset Cutting

Copying
24
2
H
After copying has finished, hold the original with one hand, press the
{
{{
{Clear/Stop}
}}
} key, and then remove the original.
Note
❒ To cancel copying, press the {Clear/Stop} key. The copier finishes the oper-
ation in progress, and delivers the copy and the original. Press the {Clear/
Stop}key to remove the original.
❒ To call off on-going copying, for example, when you have inserted a wrong
blueprint, press the {Paper Select/Cut} key. The machine interrupts the op-
eration in progress, and delivers the copy and the original. Press the {Clear/
Stop} key to remove the original.
Preset Cutting
This function cuts roll paper to a selected length. The paper is cut to this length
regardless of the size.
Note
❒ The default preset cut lengths are as follows. Metric Version: 1189mm,
841mm, 594mm, 420mm, 297mm Inch Version: 48.0", 42.0", 36.0", 24.0", 18.0",
11.0" To change the preset cut length pattern, please contact your service rep-
resentative.
A
Press the {
{{
{Paper Select/Cut}
}}
} key to turn on the Paper Select indicator.