Basics
8
1
Recommended Paper
Standard paper sizes that can be used in this copier are shown below.
Note
❒ When you make a copy on a non-standard size of paper, set the paper in the
bypass tray.
❒ Weight of paper suitable for this copier: 51g/m
2
, 14lb to 134g/m
2
, 36lb.
❒ Do not use the following kinds of paper or a paper jam might occur.
• Bent, folded, or creased paper
•Torn paper
•Perforated paper
•Non-smooth paper
• Slippery paper
• Thin paper that has low stiffness
❒ Do not make a copy on paper with any kind of coating, such as thermosensi-
tive paper, art paper, aluminum foil, and carbon paper. A fault might occur.
❒ Do not use paper with strong curls at the edges or corners. (Curls rising more
than 5mm (1/4") or falling more than 20mm (3/4") over a 40mm (1.5") radius.)
❒ When you make copies on film, take out the copies delivered to the copy exit
guide one sheet at a time and place them on a flat surface.
❒ If copying to natural tracing paper (all pulp, translucent paper) at a relative
humidity of 35% or less
A
If the paper was left out of its package for 5 minutes or more, remove
the first 1000mm (39.3") before copying.
B
If copies come out wavy or with white spots, use translucent paper in-
stead of natural tracing paper.
C
Always keep the paper in a bag when not using it.
• Store the paper in a sealed polyvinyl bag if not used for a long period.
If it gets humid, paper will curl or wave which can cause a paper jam or
part of the image not to be copied.
Metric ver-
sion
Inch ver-
sion
Bypass Roll Feeder
A0 E (36"
×
48") KK
A1 D (24"
×
36") KL KL
A2 C (18"
×
24") KL KL
A3 B (12"
×
18") KL KL
A4 A (9"
×
12") KK
To Next Page
Loading...
