Ref. What it is What it does
6
Set Paper
and
RF Select
indicators
These usually light up together. They light when you can
set paper on the table or select and start the roll feeder. If
you don’t have the roll feeder option, the RF Select
indicator will not light.
Wait indicator Shows that the copier is not yet ready to copy.
7
Clear Modes/Stand-by
key
Returns the copier to the default settings. Press and hold
3 sec. to let the fusing unit cool down. This saves energy,
but increases the waiting time at the next copy job.
8
Program key Allows you to recall or set a program.
9
Function Select key Lets you switch your input from, the lead margin, the copy
counter, or the paper length. (See
1
.) Also used for
copying a selected portion of the original.
10
Paper Length
indicator & Copy
Counter
1) Shows the length of paper the roll feeder will send.
2) Shows the number of copies to make.
3) Displays FULL when the used toner bottle needs to be
emptied.
11
Preset Cut key Scrolls through the preset paper lengths for the roll feeder.
12
RF Select key Selects the roll feeder as the source of copy paper.
13
Copy Media key
Tells the copier what kind of copy paper you are using.
The copier will apply more or less heat accordingly.
Vellum Shows when vellum is the selected copy media.
and Film Shows when film is the selected copy media.
indicators When both indicators are off, the copier is set for plain
copier paper.
14
Emergency Stop
Pressing this key will stop the copying process immedi-
ately. Use if your original is getting stuck in the copier.
15
Density indicator Shows the density level the copies will have.
Darker key The Darker key will increase the density.
Lighter key The Lighter key will decrease the density.
16
Clear Stop key Tells the copier to stop copying and clear the copier. (The
copier will finish the copy, feed out the original, and stop.)
Displays and Keys WHERE IS IT & WHAT IS IT
39
To Next Page
Loading...
