Ref. What it is What it does
1, 1a
Locks Squeeze both locks to open the unit. Open the unit to
empty the used toner bottle and to remove jammed paper.
2
Front cover Open this cover (and the unit) to access the toner
cartridge.
3
Original table Place your original here, face up. If you want to copy a
stiff original that can’t be bent, use the rear table (see
7
).
4
Holder for the
operating
instructions
Place this booklet here when you’re not reading it.*
5
Copy exit guide Makes sure the copies don’t fall off as they come out.
6
Operation panel See page 38.
7
Rear table 1) Place stiff originals here, face down.
2) Open to remove jammed paper from fusing unit.
8
Roll feeder (option) Feeds paper from a roll to the copier.
9, 9a
Guides (option) Use the guides to keep the original and copy paper going
straight as you feed them into the copier.
10
Copy table Open this table if you are copying to sheets, changing the
toner cartridge, or if you have to open the unit.
11
Original exit The original will come out from here after it is copied.
12
Roll feeder covers Open these covers to change the roll of paper and to clear
paper jams.
13
Copier table (option) Holds your copier and roll feeder.
14
Main switch
Turn on to start the copier and off when you’re done for
the day. The copier will need about 5 minutes to warm up
if it’s been turned off for a long time.
*Please!
The Outside Of The Copier WHERE IS IT & WHAT IS IT
41
To Next Page
Loading...
