Power connection
p
Connect the copier to a power source meeting the specifica-
tions given on the inside front cover of this manual.
p
Do not set anything on the power cord.
p
Voltage must not fluctuate more than 10%.
p
Make sure the copier is grounded.
p
Avoid multiwiring.
p
Make sure the plug is firmly inserted into the power outlet.
p
Make sure the power outlet is close to the copier and easily ac-
cessible at all times.
Clearance
Place the copier near a power source and provide clearance as shown
below.
Left
600 mm
(23.6")
Front
1000 mm (39.4")
Back
600 mm (23.6")
WHERE TO PUT YOUR COPIER
43
To Next Page
Loading...
