Ricoh GR III - Sharing Images; Using the Camera with a Computer

5
Sharing Images
110
Sharing Images
Using the Camera with a Computer
Connect the camera to a computer using the provided USB cable.
1 Turn the camera off.
2 Open the terminal cover of the
camera, and connect the USB cable to
the USB terminal.
3 Connect the USB cable to the USB port of the computer.
The camera turns on and enters the playback mode.
The camera is recognized as a device by the computer.
When a memory card is inserted, the files on the memory card are displayed.
When a memory card is not inserted, the files in the internal memory are
displayed.
4 Copy the captured images to the computer.
5 Disconnect the camera from the computer when the copy is
complete.
6 Remove the USB cable from the camera.
Caution -------------------------------------------------------------------------------------------------------
• Do not remove the USB cable while copying images.
• If the battery level is low, it may take some time until the camera is recognized by the computer.
Memo ---------------------------------------------------------------------------------------------------------
• When the camera is connected to a computer, it is recognized as a device with the name “RICOH
GR IIIx”.
• The battery is charged when the camera is connected to the computer and the camera is turned off.
• Refer to “Operating Environment” (p.153) for system requirements to connect the camera to a com-
puter.
Downloaded from ManualsNet.com search engine