PAPER FEED, TRANSPORT, OUTPUT
J001/J003 6-28 SM
6.7.2 CASSETTE LOCK/RELEASE
Cassette arms [B] on both sides of the cassette are guided into rails when the
paper cassette [A] is pushed into the printer. Then the bottom plate gets raised [C].
This raises the paper in the cassette to the correct height for paper feed.
A pawl on bottom plate of the paper cassette slides into a locking hole [D] below
the cassette. This locks the cassette in place.
When the output tray is raised with the paper cassette locked in position, this
presses the output tray arm down onto a release lever [E]. The release lever, linked
to a release arm [F], raises the pawl of the paper cassette out of its locking hole.
A spring at the front edge of the cassette nudges the paper cassette, slightly
ejecting the cassette from the printer. This opens the paper cassette for loading
paper.
Important
• The paper cassette is loaded with the cassette pulled out but still attached to the
printer.
• Never attempt to completely remove the paper cassette from the machine to load
paper.
G707D934.BMP
G707D935.BMP
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
