TROUBLESHOOTING
J006 10 SM
4.2 STATUS MONITOR MESSAGES
J001/J003 Manual Reference
4.1.2 Status Monitor Messages
Comment
The shaded status monitor messages in the table below have
been added for the J006.
NOTE: The exact wording of the Status Monitor messages that appear on the
screen may be different.
Status Display
Status
Message Display
Operational Normal
Ready
Operational Printing
Printing...
Operational Drying
Inkjet Transparency sheet-dry print delay has been enabled.
Please wait.
Warming Up/Adjusting... Preparing (Warming Up)
Please wait.
Warming Up/Adjusting... Temperature Out of Range –
Low (Recoverable)
Room temperature is out of the printable temperature range.
Adjust the room temperature to a suitable range and wait for a
while before using the printer. Click [User Guide] for further
information.
Warming Up/Adjusting... Temperature Out of Range –
High (Recoverable)
Room temperature is out of the printable temperature range.
Adjust the room temperature to a suitable range and wait for a
while before using the printer. Click [User Guide] for further
information.
Loading from Cartridge... Supplying Ink
Please wait.
Cleaning Print-heads... Servicing Print Heads
Please wait.
Operational Resetting Job
Resetting job(s)...
No Response from Printer Power Off
Check the power and cables. Click [User Guide] for further
information.
Operational Ink Supply Low (K)
Replace cartridge(s). Cartridge(s) are empty. Open the
indicated cover and replace the cartridge(s). [Right Front
Cover]: [Black] When multiple cartridges need replacing, pull
out all empty cartridges first, then insert the new ones. Click
[User Guide] for further information.
Operational Ink Supply Low (C)
Replace cartridge(s). Cartridge(s) are empty. Open the
indicated cover and replace the cartridge(s). [Right Front
Cover]: [Cyan] When multiple cartridges need replacing, pull
out all empty cartridges first, then insert the new ones. Click
[User Guide] for further information.
To Next Page
Loading...
