SM 8-27 J001/J003
1-3 Wait for a few minutes, switch the printer on, and confirm
whether this error occurs again.
119.3°F).
confirm whether the printer is restored to normal
operation.
8.3.5 SUPPLYING INK
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Supplying ink.
The printer is warming up after being switched on, or doing
routine maintenance after a print cartridge has been replaced.
Print head maintenance in progress.
(1) After print head maintenance is finished, make sure that the
printer enters the "Ready" mode for normal operation.
Print head maintenance in progress. Wait for the printer to enter the "Ready" mode after print
head maintenance is finished.
8.3.6 PRINT CARTRIDGE EMPTY
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Ink near end.
The print cartridge is almost empty and momentarily printing will
no longer be possible.
A print cartridge has run out of ink during a print job.
Replace the print cartridge. A print cartridge has run out of ink during a print job. Replace the print cartridge.
8.3.7 INK OUT
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Ink out.
The print cartridge is empty and printing is no longer possible.
A print cartridge has run out of ink during ink supply.
Replace the print cartridge. A print cartridge has run out of ink during a print job. Replace the print cartridge.
8.3.8 PRINT CARTRIDGE MISSING/INCORRECTLY SET
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Print cartridge loose.
Check the print cartridges and make sure none of them are
loose.
Print cartridges set incorrectly.
Damaged.
(1) Check all the print cartridges and make sure they are not
loose.
Print cartridges set incorrectly. Reset the print cartridges.
8.3.9 INK WASTE TANK NEEDS REPLACEMENT
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
Ink Waste Tank Nearly Full.
The internal unit requires replacement.
At power on, or during a print job, the printer detected that the
waste ink tank is nearly full.
To Next Page
Loading...
