Before Installation, Maintenance
Shipping and Moving the Machine
CAUTION
1. Work carefully when lifting or moving the machine. If the machine is heavy,
two or more customer engineers may be required to prevent injuries (muscle
strains, spinal injuries, etc.) or damage to the machine if it is dropped or
tipped over.
2. Personnel moving or working around the machine should always wear proper
clothing and footwear. Never wear loose fitting clothing or accessories
(neckties, loose sweaters, bracelets, etc. ) or casual footwear (slippers,
sandals, etc.) when lifting or moving the machine.
3. Always unplug the power cord from the power source before you move the
machine. Before you move the machine, arrange the power cord so it will not
fall under the machine.
Power
Warning
1. Always turn the machine off and disconnect the power plug before doing any
maintenance procedure. After turning the machine off, power is still supplied
to the main machine and other devices. To prevent electrical shock, switch
the machine off, wait for a few seconds, then unplug the machine from the
power source.
2. Before you do any checks or adjustments after turning the machine off, work
carefully to avoid injury. After removing covers or opening the machine to do
checks or adjustments, avoid touching electrical components or moving parts
(gears, timing belts, etc.).
3. After turning the machine on with any cover removed, keep your hands away
from electrical components and moving parts. Never touch the gears, timing
belts, etc.
Installation, Disassembly, and Adjustments
CAUTION
1. After installation, maintenance, or adjustment, always check the operation of
the machine to make sure that it is operating normally. This ensures that all
shipping materials, protective materials, wires and tags, metal brackets, etc.,
(attached to protect the machine during shipping), have been removed and
that no tools remain inside the machine.
2. Never use your fingers to check moving parts that are causing spurious
noise. Never use your fingers to lubricate moving parts while the machine is
operating.
To Next Page
Loading...
