Ricoh J006 - Page 458

SP Tables
SM 5-23 J007/J010/J011
J007/J010
J011
 Print head 1.
 Print head 2.
 Print head 3.
 Print head 4.
Initial Fill Counter Reset
1. Turn the printer off.
2. After executing this menu, turn the printer on to start initial filling of the print
head tanks.
3. After executing this menu, the carriage adjustment mode can be executed.
5102
CARRIAGE
ADJUST
Set Printer n Carriage Adjust Mode
Use this SP to adjust the print head gap after print head replacement and print
the Nozzle Check pattern.
Carriage Adjustment Mode Flow
Before executing this menu, you must execute the carriage replacement mode.
1. Print the print head gap adjustment chart (High Speed).
2. Adjust the gap (High Speed).
3. Print the print head gap adjustment chart (High Speed).
4. Print the print head gap adjustment chart (Std. (Speed Priority). Std. (Quality
Priority)).
5. Adjust the gap (Std. (Quality Priority, Std. (Speed Priority)).
6. Print the print head gap adjustment chart (Std. (Speed Priority). Std. (Quality
Priority)).
7. Print the print head gap adjustment chart (High Quality).
8. Adjust the gap (High Quality).
9. Print the print head gap adjustment chart (High Quality).
10. Print the Nozzle Check test pattern.
5200 PRINT SMC Print an Engine Maintenance Summary
Use this SP to print an engine maintenance summary. You need at least 8 sheets
of paper to do this print. It will take at least 3 minutes before the print will start.
5300 DUMMY NUMBER Set a Dummy Number
Use this SP to set the dummy number. Operation Panel Flow
Input Check: Sensors 1/2
5400 INPUT CHK1 Check Input Sensors (1)
Use this SP to display the on/off status of each sensor. The status of each sensor
(O, X) is displayed on the 2nd line of the display.
No. Meaning No. Meaning
1 Ink Cartridge Set Switches 9 PFU Set Sensor
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA