Ricoh MP C401 Series User Manual

Messages Displayed When You Use the Printer
Function
This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.
Messages Displayed on the Control Panel When You Use the Printer Function
• Before turning off the power, see page 53 "Turning On/Off the Power".
Message Causes Solutions
"Hardware Problem:
Ethernet"
An error has occurred in the
Ethernet interface.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem: HDD" An error has occurred in the
hard disk.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem: USB" An error has occurred in the
USB interface.
Turn off the power, and then back on
again. If the message appears
again, contact your service
representative.
"Hardware Problem:
Wireless Card"
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
The wireless LAN board can be
accessed, but an error was
detected.
Turn off the power, and then confirm
the wireless LAN board is inserted
correctly. And then, turn on the
power again. If the message
appears again, contact your service
representative.
10. Troubleshooting
178

Ricoh MP C401 Series Specifications

General

Print Technology	Laser
Resolution	1200 x 1200 dpi
Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Monthly Duty Cycle	Up to 150, 000 pages
Copy Resolution	600 x 600 dpi
Fax Speed	33.6 kbps
Processor	533 MHz
Operating System Compatibility	Windows, Mac OS, Linux
Print Speed	40 ppm (A4)
Connectivity	USB, Ethernet
Supported Paper Sizes	A3, A4, A5, B4, B5, Letter, Legal, Executive, Folio
Scanner Type	Flatbed, ADF
Scan Resolution	600 dpi
Copy Speed	40 cpm (A4)
Control Panel	color touchscreen
Memory	1.5 GB RAM