• For details about Prevent Paper Abrasion mode, see p.161 "Checking Whether the Print-heads
Scratch the Paper".
• For details about Manual Adjust Head Position, see p.169 "Manual Adjust Head Position".
Manual Adjust Head Position
If Auto Adjust Head Position has failed, perform Manual Adjust Head Position.
To check the print results of the test pattern, proceed to step 5.
• Printing the test pattern consumes ink. Perform this function only when necessary.
• Adjustment results vary depending on the Prevent Paper Abrasion mode's status. If you perform an
adjustment while Prevent Paper Abrasion mode is enabled and do not want to print using this
mode, cancel Prevent Paper Abrasion mode, and then perform the adjustment again.
• Perform no other operations while the test pattern is printing.
• An error will occur and test patterns will not print if:
• There is a misfeed.
• One of the machine's covers is open.
• The machine is performing maintenance operations.
• The machine has run out of ink.
• The machine has run out of paper.
1. Press the [User Tools/Counter] key.
To Next Page
Loading...
