129
Replacing the ADF Snap-in Pad
After scanning approximately 30,000 pages through the ADF, the pad may be worn
out and you may experience problems with document feeding. In this case, it is
highly recommended to replace the pad module with a new one. For ordering the
pad module, please consult your nearest dealer and follow the procedure below to
replace it.
Disassembling Procedure
1. Gently open the ADF front cover to the left.
2. Press both sides of the ADF snap-in pad inwardly with your fingers to pull out
the ADF snap-in pad from the slot.
Assembling Procedure
1. Take out the ADF pad module from the box.
2. Press both arms of the ADF snap-in pad module inwardly with your two
fingers.
3. Place it into the holes until it snaps into place.
ADF Pad
To Next Page
Loading...
