Ricoh PRO C7200 - Page 167

1.SC Codes
163
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
43
B
Corner Stapler Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Replace the Corner Stapler Motor, reconnect the connector.
 Replace the Stapler Rotation HP Sensors (front, rear), reconnect the
connectors.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the stapler mechanism.
 Resolve the mechanical failure for the stapler unit mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
44
B
Booklet Stapler Motor Error
 The corner stapler did not operate within specified time
 When moving to the home position, home position was not detected within
specified time. (The first time: jam display, the second time: SC)
 Staple jam
 Overload (too many sheets for stapling)
 Remove the pieces of staples.
 Replace the cartridge.
 Replace the Booklet Stapler Motor
 Replace the harness.
 Replace the Main Board.
 Resolve the mechanical failure for the stapler unit mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
50
B
Booklet Stapler Side Fence Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)