Ricoh PRO C7200 - Page 170

1.SC Codes
166
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the Turn Guide Motor Error, reconnect the connector.
 Replace the Stack JG HP sensor, reconnect the connector.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the booklet stack mechanism.
 Resolve the mechanical failure for the staple tray mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
60
B
Booklet Stapler Motor Error
 The booklet stapler did not operate within specified time. (The first time: jam
display, the second time: SC)
 When moving to the home position, home position was not detected within
specified time. (The first time: jam display, the second time: SC)
 Staple jam
 Overload (too many sheets for stapling)
 Motor defective
 Connecter disconnected
 Home position sensor defective
 Remove the pieces of staples.
 Replace the cartridge.
 Replace the Booklet Stapler Motor, reconnect the connector.
 Replace the harness.
 Replace the Main Board.
 Resolve the mechanical failure for the stapler unit mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
70
B
Shift Tray Lift Motor Error
 When descending, Paper Height Sensors are still detecting paper after
specified time. (The first time: jam display, the second time: SC)
 When ascending, Paper Height Sensors did not detect top side of paper
within specified time. (The first time: jam display, the second time: SC)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Replace the Shift Tray Lift Motor, reconnect the connector.
 Replace the Paper Height Sensors (TE, shift), reconnect the connector.