Ricoh PRO C7200X - Page 163

1.SC Codes
159
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-
31
B
Jogger Motor (Front) Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor defective
 Connecter disconnected
 Overload
 Home position sensor defective
 Replace the Jogger Motor (Front), reconnect the connector.
 Replace the Jogger Fence HP Sensor (Front), reconnect the connector.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the stapler mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-32
B
Jogger Motor (Rear) Error
Same as SC720-31
Same as SC720-31
 Replace the Jogger Motor (Rear), reconnect the connector.
 Replace the Jogger Fence HP sensor (Rear), reconnect the connector.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the stapler mechanism.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC720-33
B
Positioning Roller Lift Motor Error
Same as SC720-31
Same as SC720-31
 Replace the Positioning Roller Lift Motor, reconnect the connector.
 Replace the Positioning Roller HP Sensor, reconnect the connector.
 Replace the harnesses.
 Replace the Main Board.
 Resolve the mechanical failure for the stapler mechanism.