Ricoh PRO C7200X - Page 315

1.SC Codes
311
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Replace the harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
77
B
Perfect Binder: Trim unit entrance sensor late error
The stack was late arriving because the trim unit entrance sensor did not go ON
even after a transport end signal was received.
 Signature jam occurred between the cover transport unit and signature
rotation unit.
 Trim unit entrance sensor defective
 Signature exit roller motor defective
 Slave control board defective
 Cutter control board defective
 Connector loose, broken, defective
 Reconnect the connector.
 Replace the signature exit roller motor.
 Replace the trim unit entrance sensor.
 Replace the slave control board.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
78
B
Perfect Binder: Book registration sensor late error
At the start of cutter registration, the book registration did not go ON.
 Signature jam occurred in the signature rotation unit.
 Book registration sensor defective
 Connector loose, broken, defective
 Cutter control board defective