Ricoh PRO C7200X - Page 316

1.SC Codes
312
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector.
 Replace the book registration sensor.
 Replace the cutter control board.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
79
B
Perfect Binder: Signature exit sensor lag error
When the power was turned on, the cover path was closed and the signature exit
sensor detected paper present, but the LE detect sensor had detected no paper
present.
 Signature exit sensor defective
 Signature jam occurred in the cover transport unit when the power was turned
on.
 Connector loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the signature exit sensor.
 Replace the leading edge sensor.
 Replace the slave control board.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
80
B
Perfect Binder: Entrance path sensor late error
During the automatic exit operation, the entrance path sensor could not detect any
paper within 6860 ms after gluing and stack transport started.
 Signature jam occurred between the cover transport unit and signature
rotation unit during the automatic exit operation.
 Trim unit entrance sensor defective
 Stack transport roller defective
 Connector loose, broken, defective
 Slave control board defective