Ricoh PRO C7200X - Page 317

1.SC Codes
313
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector.
 Replace the signature exit roller motor.
 Replace the trim unit entrance sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
81
B
Perfect Binder: Main grip late error
There was no stack received from the sub grip unit; the main grip signature
sensor detected no stack.
 Signature jam occurred in the sub grip unit.
 Signature move motor defective
 Main grip signature sensor defective
 Connector loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the signature move motor.
 Replace the main grip signature sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
82
B
Perfect Binder: Trim unit entrance sensor lag error
At the end of initialization at power on, the entrance path sensor went ON.
 Signature jam occurred in the trim unit.
 Trim unit entrance sensor defective
 Connector loose, broken, defective
 Cutter control board defective
 Reconnect the connector.