Ricoh PRO C7200X - Page 318

1.SC Codes
314
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the trim unit entrance sensor.
 Replace the cutter control board.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-
83
B
Perfect Binder: Book registration sensor lag error
 Book registration sensor detected ON at the end of initialization after power
on.
 Book registration sensor detected ON at the end of automatic exit operation.
 Book registration sensor detected ON at the end of book binding and
automatic exit.
 Book registration sensor could detect no stack at fore edge cutting.
 Book registration sensor detected ON at end of grip operation during book
binding.
 Signature jam occurred in the book lift tray
 Book registration sensor defective
 Connector loose, broken, defective
 Cutter control board defective
 Reconnect the connector.
 Replace the book registration sensor.
 Replace the cutter control board.
 Replace the sensor harness.
 Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC753-84
B
Perfect Binder: Book arrival sensor lag error
Not detected
 Sensor defective
 Book failed to reach output tray
 Fore edge trim scraps fell into output area
 Not detected