Ricoh PRO C7200X - Page 324

1.SC Codes
320
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Front door solenoid defective
 Front door lock release sensor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the front door solenoid.
 Replace the front door lock release sensor.
 Replace the master control board.
 Replace the solenoid harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
16
B
Perfect Binder: Front door force open error
The front door open was detected open, even though it was locked.
 Front door switch defective
 Front door solenoid defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the front door solenoid.
 Replace the front door switch.
 Replace the master control board.
 Replace the solenoid harness.
 Replace the switch harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
17
B
Perfect Binder: Switchback flapper HP sensor late error
During the switchback flapper lift operation, the switchback flapper HP sensor did
not go ON, even though the switchback flapper motor operated long enough for
lifting through an arc of 50 degrees
 Switchback flapper HP sensor defective
 Switchback flapper motor defective
 Connector loose, broken, defective