Ricoh PRO C7200X - Page 323

1.SC Codes
319
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
13
B
Perfect Binder: Glue roller HP sensor lag error
During glue supply, the glue roller HP sensor did not go OFF, even though the
glue roller motor was operating for 2400 ms.
 Glue pellets jammed
 Glue supply motor defective
 Glue roller HP sensor defective
 Connector loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the glue supply motor.
 Replace the glue roller HP sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
14
B
Perfect Binder: Front door lock error
Front door lock release sensor did not go off, even though the door was locked.
 Front door solenoid defective
 Front door lock release sensor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the front door solenoid.
 Replace the front door lock release sensor.
 Replace the master control board.
 Replace the solenoid harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
15
B
Perfect Binder: Front door lock release error
The front door lock release sensor did not go ON, even though the door was
unlocked.