Ricoh PRO C7200X - Page 322

1.SC Codes
318
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
11
B
Perfect Binder: Glue vat roller motor error
The glue vat roller rotation sensor could not detect rotation of the glue vat roller
motor within 1200 ms of motor operation.
 Glue vat roller motor defective
 Glue vat roller rotation sensor connector defective
 Connector loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the vat roller motor.
 Replace the vat roller rotation sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
12
B
Perfect Binder: Glue roller HP sensor late error
During glue supply, the glue roller HP sensor did not go ON, even though the glue
roller motor was operating for 1000 ms.
 Glue pellets jammed
 Glue supply motor defective
 Glue roller HP sensor defective
 Connector loose, broken, defective
 Slave control board defective
 Reconnect the connector.
 Replace the glue supply motor.
 Replace the glue roller HP sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.