Ricoh PRO C7200X - Page 328

1.SC Codes
324
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
24
B
Perfect Binder: Jog fence front large HP sensor lag error
While large-size paper was being jogged, the jog fence front large HP sensor did
not go OFF after the front jog fence motor operated long enough for 20 mm of
feed.
 Jog fence front large HP sensor defective
 Jog fence front motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the jog fence front motor.
 Replace the jog fence front large HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
25
B
Perfect Binder: Jog fence rear HP sensor late error
While jogging small-size paper, the rear jog fence HP sensor did not go ON, even
though the jog fence motor operated long enough for 60 mm of feed.
 Jog fence rear HP sensor defective
 Jog fence rear motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the jog fence rear motor.
 Replace the jog fence rear HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.