Ricoh PRO C7200X - Page 329

1.SC Codes
325
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
26
B
Perfect Binder: Jog fence rear HP sensor lag jam
While small-size paper was being jogged, the jog fence rear HP sensor did not go
OFF after the rear jog fence motor operated long enough for 40 mm of feed.
 Jog fence rear HP sensor defective
 Jog fence rear motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the jog fence rear motor.
 Replace the jog fence rear HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
27
B
Perfect Binder: Jog fence rear large HP sensor late error
While large-size paper was being jogged, the rear jog fence large HP sensor did
not go ON, even though the jog fence rear motor operated long enough for 70mm
of feed.
 Jog fence rear large HP sensor defective
 Jog fence rear motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the jog fence rear motor.
 Replace the jog fence rear large HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.