Ricoh PRO C7200X - Page 330

1.SC Codes
326
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
28
B
Perfect Binder: Jog fence rear large HP sensor lag error
While large-size paper was being jogged, the jog fence rear large HP sensor did
not go OFF after the rear jog fence motor operated long enough for 20 mm of
feed.
 Jog fence rear large HP sensor defective
 Jog fence rear motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the jog fence rear motor.
 Replace the jog fence rear large HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
29
B
Perfect Binder: Switchback roller HP sensor late error
During the switchback roller lift operation, the switchback roller HP sensor did not
go ON, even though the switchback roller lift motor operated long enough for lifting
through an arc of 40 degrees.
 Switchback roller HP sensor defective
 Switchback roller lift motor defective
 Connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the switchback roller lift motor.
 Replace the switchback roller HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
B
Perfect Binder: Switchback roller HP sensor lag error