Ricoh PRO C7200X - Page 332

1.SC Codes
328
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Tray lower limit sensor defective
 Stacking tray lift motor defective
 Harness connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the stacking tray lift motor.
 Replace the tray lower limit sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
33
B
Perfect Binder: Paper detect sensor (front) detection error
When the stacking tray was raised, the paper detect sensor (front) did not go ON,
even after the stacking tray overflow sensor went ON and the stacking tray lift
motor had operated for 30 mm of lift.
 Paper detect sensor (front) defective
 Stacking tray lift motor defective
 Harness connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the stacking tray lift motor.
 Replace the paper detect sensor (front).
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
34
B
Perfect Binder: Perfect Binder: Paper detect sensor (front) no paper detection
error
When the stacking tray was lowered, the tray lower limit sensor did not go OFF
after the stacking tray lift motor had operated long enough for 10mm of lowering.
 Paper detect sensor (front) defective