Ricoh PRO C7200X - Page 333

1.SC Codes
329
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Stacking tray lift motor defective
 Harness connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the stacking tray lift motor.
 Replace the paper detect sensor (front).
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
35
B
Perfect Binder: Paper detect sensor (rear) paper detection error
When the stacking tray was raised, the paper detect sensor (rear) did not go ON,
even after the stacking tray overflow sensor went ON and the stacking tray lift
motor had operated for 40 mm of lift.
 Paper detect sensor (rear) defective
 Stacking tray lift motor defective
 Harness connector loose, broken, defective
 Master control board defective
 Reconnect the connector.
 Replace the stacking tray lift motor.
 Replace the paper detect sensor (rear).
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC754-
36
B
Perfect Binder: Paper detect sensor (rear) no paper detection error
When the stacking tray was lowered, the paper detect sensor (rear) did not go
OFF after the stacking tray lift motor had operated long enough for 10mm of
lowering.
 Paper detect sensor (rear) defective
 Stacking tray lift motor defective