Finishing to a custom size
Specify the size of the finished bound booklets and cut three edges to a custom size.
1. Press [Cut 3 Edges].
2. Press [Specify Finishing Size].
3. Press [Custom Size].
4. Enter the horizontal and vertical length using the number keys, and then press [ ].
Press [Vertical] to enter the vertical length using the number keys.
To change the value you entered, press [Clear] and then enter a new value.
5. To adjust the cut position, press [Cut Position Fine Adj.].
6. Press [ ] and [ ] to set the top or bottom cut position, and then press [OK].
To change the value you entered, press [ ] or [ ], or press [Clear], and then specify a new value.
7. Press [OK] twice.
• You can shift the horizontal cut position from 139.7 to 216 mm (5.50 to 8.50 inches) in 0.1 mm (0.01
inch) increments.
• You can shift the vertical cut position from 201 to 297 mm (7.92 to 11.69 inches) in 0.1 mm (0.01
inch) increments.
2. Basic Copying
116
To Next Page
Loading...
